Epoxy Flake Flooring in Nashua, NH

What a flake floor is

A flake floor, sometimes called a chip or broadcast floor, is a resin system with colored vinyl flakes thrown into the wet base coat. We broadcast until the base is completely covered, wait for it to harden, scrape and vacuum away the loose chips and then seal everything under a clear top coat. The result is a speckled surface with a slight texture that looks a bit like granite. It is thicker than a plain colored coat, more forgiving of small imperfections in old concrete and much better at hiding dirt.

Why it works in a snowy climate

After a storm, the garage floor ends up with a gray haze of dried brine, sand and road film. On a solid-color floor that haze stands out right away. On a flake floor it blends into the pattern, so the garage looks clean for longer between washes. The texture also gives your boots more grip when the floor is wet. For a family that is in and out of the garage all winter, those two benefits alone usually settle the choice.

Popular color blends

• Gray, white and black: the most common pick, and the best at hiding salt residue.
• Tan, brown and cream: warm and forgiving in workshops and garages that see yard dirt and sawdust.
• Charcoal and blue-gray: a darker, modern look that pairs well with gray cabinets.
• Custom mixes: we can blend chips to match trim, cabinets or a team color.

Flake sizes also vary. Larger chips give a bolder pattern, while smaller chips look more like stone. We bring samples of both to every visit.

Full broadcast versus partial

A full broadcast covers every inch of the base coat. It gives the most texture, the thickest system and the best ability to hide dirt. A partial broadcast scatters fewer chips over a solid color, which gives a cleaner, more modern look with less texture. Partial floors show dust a little more easily, so we usually suggest full coverage in garages and partial in basements, laundry rooms or offices where salt is not part of daily life.

Preparation still comes first

Flake hides small flaws, but it cannot fix a bad bond. Every flake floor we install starts with diamond grinding, crack repair and patching of pits and spalls. We test moisture before priming, and in older basements we check for efflorescence, the white mineral crust that shows water is moving up through the slab. Getting those steps right is what keeps a flake floor attached for the long run.

Where flake floors make sense

Garages are the obvious choice, but flake systems also do well in mudrooms, basement workshops, laundry rooms, home gyms, kennels and the back rooms of small businesses. On the commercial side, we install them in auto service bays, fire and police stations, locker rooms, school hallways and break rooms, where both grip and easy cleaning matter.

Top coat options

The top coat is what you actually walk on, so it does a lot of work. Polyaspartic top coats cure quickly, resist yellowing in sunlight and handle salt and chemicals well. Urethane top coats are very tough against scratching and are common on busy commercial floors. Both can be made more slip resistant by adding a fine grit. We help you choose based on how the space gets used, not just on price.

Keeping it clean

Day-to-day care is simple. Use a squeegee during storm season, run a dust mop or broom each week and wash with a gentle cleaner every few months. A soft-bristle deck brush handles anything stubborn. Avoid acid cleaners and abrasive pads. With that little routine, a flake floor stays sharp for a very long time.

Getting an estimate

Send us photos of the space or book a visit. We will check the concrete, show you chip samples in your own lighting and give you a written quote with each step explained. You may also want to compare our garage systems or look at metallic finishes for indoor spaces.

Flake in basements and mudrooms

Inside the house, a flake floor makes a lot of sense in a back-entry mudroom where wet boots, hockey bags and dog paws come through all winter. We can carry the same blend from the garage through the mudroom door so the spaces feel connected, and we finish the edges neatly against trim and stair treads.